Seat Ateca 2017 Workshop Manual page 40

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Engine bung set - VAS 6122-
NOTICE
Secondary damage from defective needle bearing.
– If engine and gearbox are separated, needle bearing in
crankshaft must be renewed
Working sequence
• Engine/gearbox assembly removed and attached to engine
bracket - T10497- .
– Remove starter ⇒ Electrical system; Rep. gr. 27 ; Starter;
Removing and installing starter ,
– Unscrew coolant pipe from gearbox.
– Unscrew nuts -arrows-, and remove bracket at front of sump.
Note
The studs are welded on to the front of the oil pan.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Vehicles with four wheel drive:
– Unscrew bolts-1, 2- and remove the holders of the bevel box.
32
Rep. gr.10 - Removing and installing engine
⇒ page 82 .