Seat Ateca 2017 Workshop Manual page 306

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Wedge - 3409-
Removing
– Drain coolant ⇒ page 239
– Remove coolant hose at top left from radiator -arrow-.
– Remove radiator cowl
– Seal off open pipes/lines and connections immediately with
clean plugs from engine sealing cap set - VAS 6122- .
– Remove front bumper ⇒ General body repairs, exterior; Rep.
gr. 63 ; Front bumper; Removing and installing bumper cover .
– Removing the headlights ⇒ Electrical System; Rep. gr. 94 ;
Headlights; Assembly overview - Headlights .
Vehicles with coolant bearing support, clipped in
– Release catches -arrows- of radiator mounting -1- on left and
right, or cut through using side cutters.
Note
The radiator mounting carrier will be reused during installation. It
will then be bolted to the lock carrier. Bolts ⇒ ETKA (Electronic
parts catalogue) .
Vehicles with radiator mounting bracket, screwed on
– Unscrew bolts -2- of radiator mounting carrier -1- on left and
right.
298
Rep. gr.19 - Cooling
.
⇒ page 300 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.