Removing And Installing Camshaft Timing Chain - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Press on bearing saddle and press in the bolts -1 ... 6- by
hand.
– Tighten bolts for bearing saddle
The remaining installation is carried out in the reverse order, not‐
ing the following:
– Install timing chain cover (top)
Specified torques
♦ ⇒ Fig. ""Bearing saddle - specified torque and tightening se‐
quence"" , page 130
♦ ⇒ Fig. ""Lower timing chain cover – tightening sequence for
version with 8 bolts"" , page 120
♦ ⇒ Fig. ""Lower timing chain cover – tightening sequence for
version with 15 bolts"" , page 121
♦ ⇒ "3.1 Assembly overview - camshaft timing chains",
page 128
♦ ⇒ "1.1 Exploded view - cylinder head", page 105
3.4 Removing and installing camshaft tim‐
ing chain
Special tools and workshop equipment required
♦ Assembly tool - T10352A-
♦ Assembly tool - T10352/1-
♦ Assembly tool - T10352/2-
♦ Assembly tool - T10352/3-
♦ Assembly tool - T10352/4-
♦ Dowel pin - T40011-
134
Rep. gr.15 - Cylinder head, valve gear
⇒ page 130 .
⇒ page 121 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.