Seat Ateca 2017 Workshop Manual page 212

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Removing
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Place the used oil collection and extraction unit - VAS 6622A-
underneath the engine and allow the oil to drain.
Note
Please observe requirements for disposal.
– Unscrew bolts -1 ... 20-, and remove sump.
Fitting
– Install baffle plate, tightening torque
– Tighten new bolts -1- to -20- in three stages in the sequence
shown:
Stage
1. Bolts -1- to -20-
2. Bolts -1- to -20-
3. Bolts -1- to -20-
– Replenish engine oil and check oil level ⇒ Maintenance ;
Booklet 501 ; Engine oil: Draining; Renewing oil filter and re‐
plenishing engine oil .
Specified torques
♦ ⇒ "1.1 Exploded view - sump/oil pump", page 200
204
Rep. gr.17 - Lubrication
⇒ Item 7 (page 201)
Tightening sequence and tight‐
ening torque
Screw in by hand as far as stop
Tighten to 8 Nm
Turn 90° further
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.