Seat Ateca 2017 Workshop Manual page 332

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Lift charge-air cooler -1- at bottom out of the bearing supports
-arrows-.
– Remove the intercooler.
Fitting
Install in the reverse order of removal, observing the following:
Note
If there are minor dents in the fins, refer to respective instructions
⇒ page 10 .
– Insert radiator with charge air cooler -1- in mountings
-arrows- in lock carrier. Pull down lock carrier in area of mount‐
ings if necessary.
– Place the condenser -3- in the installation position.
324
Rep. gr.21 - Turbocharging/supercharging
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.