Seat Ateca 2017 Workshop Manual page 131

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew bolts -1 to 6- and remove timing chain cover (top).
– Remove bolts -3, 5- if necessary.
Installing
Install in the reverse order of removal, observing the following:
– Renew seals.
– Fit cover on cylinder head, and screw in bolts by hand. When
doing so, ensure that cylinder head gasket is seated properly
on cylinder head.
– Tighten bolts -1 to 6- in the sequence shown. For bolts -3- and
-5- use the torque wrench - V.A.G 1783- and 10 mm open-end
insert - V.A.G 1783/1-
– Install camshaft control valve 1 - N205- and exhaust camshaft
control valve 1 - N318-
– Install engine cover panel
– Install the windscreen washer tank filler ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
Specified torques
♦ ⇒ "2.1 Assembly overview - timing chain cover", page 119
2.2.2 Removing and installing timing chain
cover (bottom)
Note
Due to the adhesive strength of the sealant, the cover is bent
when being removed. For this reason, the cover always needs be
renewed.
Special tools and workshop equipment required
♦ Assembly tool - T10531-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
⇒ page 120 .
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 186 .
⇒ page 57 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
123
2. Timing chain cover