Seat Ateca 2017 Workshop Manual page 438

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew bolts -arrows- and remove heat shield for right drive
shaft.
– Disconnect the connector -1- of the oil level and temperature
sender - G266- .
– Assemble engine support - T50015A- as shown in the dia‐
gram.
♦ Screw a bolt M8 x 30 mm -1- with a washer into the threaded
hole of the subframe.
♦ Attach engine support - T50015A- -2- to support plate of po‐
sitioner - T10533/2- -4-.
♦ Fasten engine support - T50015A- assembly kit -2- and sup‐
port plate of positioner - T10533/2- -4- to the threaded hole of
the gearbox using bolt M12 x 20 mm of positioner - T10533/4-
-5-.
– By turning the spindle, the engine/gearbox unit is moved for‐
wards until there is a small tension. Avoid collisions of com‐
ponents.
– Unscrew temperature sender before particulate filter - G506-
-1- from the particulate filter.
– Open spring-type clips and detach the hoses -2- and -3- from
pressure differential sender for particulate filter - G1037-
430
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.