Seat Ateca 2017 Workshop Manual page 182

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Camshaft clamp - T40271-
♦ Cable support bracket - T10355-
♦ Engine bung set - VAS 6122-
♦ Sealant ⇒ Electronic parts catalogue (ETKA)
Removing
Note
All cable ties must be installed in their same place again.
♦
Sealing surfaces at bottom of cylinder head cover and top of
♦
cylinder head must not be machined.
The camshaft bearings are integrated into the cylinder head
♦
and cylinder head cover. The camshaft timing chain must be
relieved of tension before you remove the cylinder head cover.
– Remove noise insulation -1- ⇒ General body repairs - exterior
installation work; Rep. gr. 66 ; Noise insulation; Removing and
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
installing noise insulation .
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove air filter housing
– Remove the upper cover of the distribution chain
⇒ page 121 .
174
Rep. gr.15 - Cylinder head, valve gear
⇒ page 356 .