Removing And Installing Exhaust Flap Control Unit J883 / J945 - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew bolts -arrows- and nut -1-. Detach cover section.
– Unscrew bolts -arrows-, and detach bracket with hoses.
Installation
The assembly steps are basically a reverse of the dismantling
procedure.
Specified torques
♦ ⇒ "2.1 Assembly overview - emission control", page 414
2.4 Removing and installing exhaust flap
control unit -J883- / -J945-
Removing
Fitting location:
⇒ "1.1.8 Assembly overview - silencers, Ateca Cupra",
page 400
Control unit 2 for exhaust flaps - J945- , left side.
Control unit for exhaust flaps - J883- , right side.
– Unplug electrical connector -1- from exhaust flap control unit
-2-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
2. Emission control
443