Checking Charge Air System For Leaks - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Pull off connector -2-.
– Remove bolts -1- and pull charge pressure sender - G31- out
of air pipe.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew O-ring.
Specified torques
♦ ⇒ "2.1 Assembly overview - charge air system", page 319
♦ Assembly overview - noise insulation ⇒ General body repairs,
exterior; Rep. gr. 66 ; Noise insulation; Assembly overview -
noise insulation .
2.5

Checking charge air system for leaks

Special tools and workshop equipment required
♦ Charge air system tester - V.A.G 1687-
♦ Engine bung set - VAS 6122-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Supercharger air system:
327