Removing And Installing Fuel Pressure Sensor G247 - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
7 - Nut
❑ Qty. 1
❑ 4.5 Nm
5.2 Removing and installing fuel pressure
sensor - G247-
Special tools and workshop equipment required
♦ Measuring tool - T10118-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
♦ Bit (27 mm) - T40218- or commercially available socket
respect to the correctness of information in this document. Copyright by SEAT S.A.
(27 mm)
Use ⇒ Vehicle diagnostic tester for checking fuel pressure sender
- G247- .
If the fuel pressure sender - G247- fails, the fuel metering valve -
N290- is switched off, the electric fuel pump is fully activated and
the engine is operated with the fuel pressure which remains. This
will reduce engine torque considerably.
Removing
– Remove engine cover panel
– Remove air filter housing
– Free coolant hose -2-.
– Remove bolts -arrows-.
– Unclip front side of the air guide -1- by unlocking the retaining
tabs arrows. Remove in -direction of arrow-.
⇒ page 57 .
⇒ page 356 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
369
5. Sensors