Removing And Installing Parts Of Exhaust Gas Temperature Regulation - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1 - Temperature sender before
particulate filter - G506-
❑ Removing or installing
⇒ page 446
❑ 45 Nm
2 - Temperature sender after
particulate filter - G527-
❑ Removing or installing
⇒ page 448
❑ 45 Nm
3.2 Removing and installing parts of ex‐
haust gas temperature regulation
⇒ "3.2.1 Removing and installing temperature sender in front of
particulate filter G506 ", page 446
⇒ "3.2.2 Removing and installing temperature sender after par‐
ticulate filter G527 ", page 448
3.2.1 Removing and installing temperature
sender in front of particulate filter -
G506-
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
446
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.