Injectors; Assembly Overview - Fuel Rail With Injectors - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
2

Injectors

⇒ "2.1 Assembly overview - fuel rail with injectors", page 343
⇒ "2.2 Removing and installing fuel rail", page 345
⇒ "2.3 Injectors: removing and installing", page 346
⇒ "2.4 Renewing seals on injectors", page 350
⇒ "2.5 Cleaning injectors", page 353
2.1 Assembly overview - fuel rail with injec‐
tors
⇒ "2.1.1 Assembly overview - fuel rail with injectors, direct injec‐
tion", page 343
⇒ "2.1.2 Assembly overview - fuel rail with injectors, indirect in‐
jection", page 344
2.1.1 Assembly overview - fuel rail with injectors, direct injection
1 - Bolt
❑ Qty. 2
❑ 9 Nm
2 - Fuel rail for injectors (com‐
bustion chamber)
❑ Removing and fitting
⇒ page 345
3 - Fuel pressure sensor -
G247-
❑ Moisten taper and
thread with clean engine
oil
❑ Removing and fitting
⇒ page 369
❑ 27 Nm
4 - Pressure rings
❑ Renew after removing
5 - O-ring
❑ Renew after removing
6 - Spacer ring
❑ Renew after removing
7 - Injector
❑ Ensure correct installa‐
tion position
❑ Removing and fitting
⇒ page 346
❑ cleaning ⇒ page 353
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
8 - Washer
❑ Not installed in all vehi‐
cles
9 - Combustion chamber ring
seal
❑ Renew after removing injector
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 346
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
343
2. Injectors