Seat Ateca 2017 Workshop Manual page 248

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Draining off
CAUTION
There is an overpressure in the cooling system when the engine
is hot. Danger of scalding by steam and hot coolant.
Risk of scalding to skin and body parts.
– Wear protection gloves.
– Wear safety goggles.
– Reduce excess pressure by covering cap of coolant expan‐
sion tank with cloths and opening it carefully.
– Open filler cap -arrow- on coolant expansion tank.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Place drip tray for workshop hoist - VAS 6208- underneath.
– Lift retaining clip -3-, disconnect coolant hose (bottom right)
from radiator and drain off coolant.
Note
Ignore -items 1 and 2-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Filling
240
Rep. gr.19 - Cooling
respect to the correctness of information in this document. Copyright by SEAT S.A.