Removing And Installing Knock Sensor 1 G61 - Seat Ateca 2017 Workshop Manual

Hide thumbs Also See for Ateca 2017:
Table of Contents

Advertisement

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1.3
Removing and installing knock sensor 1
- G61-
Removing
– Unplug electrical connector -2- from knock sensor 1 - G61- .
– Remove actuator for engine temperature regulation - N493-
⇒ page 282
.
Note
Knock sensor I - G61- is located below the intake manifold and
behind the coolant pump.
– Remove knock sensor I - G61- -arrow-.
Fitting
– Install in reverse order:
– Note installation position of knock sensor I - G61- .
– Install actuator for engine temperature regulation - N493-
⇒ page 282
.
Specified torques
⇒ "2.1 Exploded view - coolant pump and thermostat",
page 268
⇒ "1.1 Assembly overview - ignition system", page 451
454
Rep. gr.28 - Ignition system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Leon 2013Leon st 2013

Table of Contents