Seat Ateca 2017 Workshop Manual page 31

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– If fitted, remove windscreen washer tank -1- ⇒ Electrical sys‐
tem; Rep. gr. 92 ; Windscreen washer system; Removing and
installing windscreen washer tank .
– Before removing, mark direction of rotation of poly V-belt with
chalk or felt-tipped pen for re-installation.
– To slacken poly V-belt turn tensioner in clockwise direction
-arrow-.
– Remove poly V-belt from pulley of air conditioner compressor
and release tensioner. Remove locking pin - T10060 A- if nec‐
essary.
Vehicles with auxiliary radiator (left-side)
– Lift retaining clips -1, 2-, disconnect coolant hoses and drain
off coolant.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Vehicles with particulate filter, all-wheel drive and front-wheel
drive
– Unclip wiring -1- and unscrew nuts -arrows-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
23