Seat Ateca 2017 Workshop Manual page 114

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1 - Dowel pin
2 - Cylinder head gasket
❑ Renew after removal
❑ Observe installation po‐
sition: parts number on
cylinder head
3 - Cylinder head
❑ Removing and fitting
⇒ page 108
❑ check for deformation
⇒ page 107
4 - Bolt
❑ Renew after removing
❑ Note procedure when
loosening ⇒ page 107
❑ Note procedure when
tightening ⇒ page 107
❑ 8 Nm + turn 90° further.
5 - Shield
6 - Bolt
❑ 9 Nm
7 - Bolt
❑ 9 Nm
8 - Shield
9 - Bolt
❑ 9 Nm
10 - Bolt
❑ 9 Nm
11 - Connection
❑ For coolant hose
12 - O-ring
❑ Renew after removing
❑ Lubricate with coolant
13 - Cylinder head bolt
❑ Renew after removal
❑ Note procedure when loosening
❑ Note procedure when tightening
14 - O-ring
❑ Renew after removing
❑ Lubricate with coolant
15 - Connection
❑ For coolant hose
16 - Bolt
❑ 9 Nm
17 - Support bracket
❑ For engine cover panel
106
Rep. gr.15 - Cylinder head, valve gear
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 107
⇒ page 107