Exploded View - Coolant Temperature Sensors; Removing And Installing Toothed Belt For Coolant Pump - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
2.3

Exploded view - coolant temperature sensors

1 - Retaining clip
❑ Ensure correct seating
2 - O-ring
❑ Renew
3 - Coolant temperature send‐
er at the radiator outlet - G83-
❑ Removing and fitting
⇒ page 285
4 - Electric connector
5 - Coolant temperature sen‐
sor - G62-
❑ On cylinder head (gear‐
box end)
❑ Removing and fitting
⇒ page 284
6 - O-ring
❑ Renew
❑ Lubricate with coolant
7 - O-ring
❑ Renew
❑ Lubricate with coolant
8 - Bolt
❑ Renew
❑ 4 Nm +45°
2.4 Removing and installing toothed belt for
coolant pump
Special tools and workshop equipment required
♦ Tool insert - T10360-
Removing
– Drain coolant ⇒ page 239
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
EA 888 III. Gen) - Edition 10.2018
2. Coolant pump/thermostat assembly
273