Seat Ateca 2017 Workshop Manual page 250

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Operation process
– Connect coolant hose with plug-in connector -3- to radiator at
bottom right ⇒ page 292
– Connect connector of radiator outlet coolant temperature
sender .
– Fill coolant expansion tank of -VAS 6096- with 10 litres of pre-
mixed coolant in correct mixture ratio; mixture ratio
⇒ page 241 .
– Screw down adapter for cooling system tester - V.A.G 1274/8-
to coolant expansion tank.
– Place cooling system charge unit - VAS 6096- on adapter -
V.A.G 1274/8- .
– Feed vent hose -2- into a small container -3-.
Note
Exhaust air takes a slight quantity of coolant along with it; this
should be collected.
– Close both valves -A- and -B- (turn lever at right angles to di‐
rection of flow).
– Fit hose -3- to compressed air supply with a pressure of
6 ... 10 bar.
– Connect ⇒ Vehicle diagnostic tester, and select following func‐
tions.
♦
0001 - Fill/bleed cooling system
242
Rep. gr.19 - Cooling
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.