Removing And Installing Oil Pressure Switch F1 - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
4.4 Removing and installing oil pressure
switch - F1-
Special tools and workshop equipment required
♦ 24 mm jointed spanner - T40175-
Removing
Vehicles with windscreen washer tank, right side:
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling tank for windscreen washer system .
Continued for all vehicles
Note
Place a cloth underneath bracket for ancillaries to catch any
♦
escaping engine oil.
Renew the seal each time the oil pressure switch has been
♦
loosened.
– Detach electrical connector -arrow- from oil pressure switch -
F1- .
– Remove oil pressure switch -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Fitting
respect to the correctness of information in this document. Copyright by SEAT S.A.
Installation is carried out in the reverse order; note the following:
Note
Renew seal.
♦
Screw oil pressure switch - F1- immediately into bore to avoid
♦
loss of oil.
– Install the windscreen washer tank filler ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
– Check oil level ⇒ page 203
Specified torques
♦ ⇒ "4.2 Exploded view - oil pressure switches/oil pressure con‐
trol", page 222
224
Rep. gr.17 - Lubrication
.