Seat Ateca 2017 Workshop Manual page 72

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Check if turning over tool -A- slides easily over clamping
pieces -B-. If necessary, turn tensioning bolt -arrow-.
Note
Now, do not turn the tensioning bolt anymore, otherwise the
clamping pin - T10531/2- will be jammed when it is screwed into
the crankshaft.
– Screw clamping pin - T10531/2- into crankshaft, and tighten it
hand-tight with a 12 mm open-end spanner -A-.
– Tighten tensioning bolt -A- hand-tight. This will lock the chain
sprocket in position relative to crankshaft.
– Unscrew knurled screw -arrows-. Remove support - T10531/1-
and vibration damper -A-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
64
Rep. gr.13 - Crankshaft group