Seat Ateca 2017 Workshop Manual page 141

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
♦ Assembly tool - T10352/1-
♦ Assembly tool - T10352/2-
♦ Assembly tool - T10352/3-
♦ Assembly tool - T10352/4-
Removing
– Remove the upper cover of the distribution chain
⇒ page 121 .
Note
The timing valves have a left-hand thread.
– Turn assembly tool -1- in -direction of arrow- to remove timing
valve on left and right.
Depending on the current model version of the timing valve, one
of the tools shown must be used:
♦ Installation tool - T10352-
♦ Installation tool - T10352/1-
♦ Installation tool - T10352/2-
♦ Installation tool - T10352/3-
♦ Installation tool - T10352/4-
– Unscrew bolts -1 ... 6- and bearing saddle without canting it,
carefully pull out.
• Carefully pull off bearing saddle; do not tilt it.
– Remove bearing saddle.
Installing
– Lubricate holes -arrows- with engine oil.
– Check that roll pin -1- is fitted.
• Carefully attach bearing saddle; do not tilt it. Risk of damaging
it.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
133
3. Chain drive