Seat Ateca 2017 Workshop Manual page 355

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Fit impact sleeve -T10133/18- over injector.
– Carefully loosen injector with light blows of a plastic hammer
-1- onto impact sleeve.
Removing injectors, version A
Note
To pull out injector, use a torque wrench set to 5 Nm.
– Insert puller -T10133/2A- into groove in injector.
– Then fit guide puller T10133/16A .
– Pull out injector by turning bolt with torque wrench -1-.
– If torque limit of »5 Nm« has been reached and the injector still
cannot be pulled out, remove puller and use impact sleeve
again to release injector.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Note
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Observe correct torque to avoid irreparable damage to injector.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
347
2. Injectors