Seat Ateca 2017 Workshop Manual page 168

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Cable support bracket - T10355-
♦ Engine bung set - VAS 6122-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Sealant ⇒ Electronic parts catalogue (ETKA)
Removing
Note
Sealing surfaces at bottom of cylinder head cover and top of
♦
cylinder head must not be machined.
The camshaft bearings are integrated into the cylinder head
♦
and cylinder head cover. The camshaft timing chain must be
relieved of tension before you remove the cylinder head cover.
Fit the cable ties in the original position when installing.
♦
– Remove air filter housing
– Remove upper coolant pipe
– Remove ignition coils
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
160
Rep. gr.15 - Cylinder head, valve gear
⇒ page 356 .
⇒ page 289 .
⇒ page 452 .