Seat Ateca 2017 Workshop Manual page 378

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew bolts -arrows- for coolant pipe from the intake mani‐
fold.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Free coolant hose -3-.
– Unplug electrical connector -1- at charge pressure sender -
G31- .
– Remove bolts -arrows-.
– Loosen hose clip -2- on air hose and pull air hose downwards
off throttle valve module - GX3- .
– Remove intake manifold support; to do so, unscrew nut -2- and
bolt -3-.
– Remove rubber bush -1- for intake manifold support.
– Release connector on fuel pressure sender - G247- -1- using
assembly tool - T10118- .
370
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.