Seat Ateca 2017 Workshop Manual page 258

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Procedure:
– Remove engine cover panel
– Drain coolant ⇒ page 239
– With coolant hose pulled off, pour approximately 1 litre of dis‐
tilled water into the coolant expansion tank.
– Drain coolant into drip tray .
– Re-connect detached coolant hoses.
Preparing coolant flushing and filling device - VAS 531 007- :
– Fill container »1« with 30 l of distilled water.
– Fill container »2« with 30 l of coolant. Mixture ratio is 50:50 for
frost protection down to approx. -36°C.
– Empty containers »3« and »4«.
– Remove valve block from plug-in connector on equipment trol‐
ley.
– Connect coolant flushing and filling device - VAS 531 007- to
battery.
Bleeding coolant flushing and filling device - VAS 531 007- :
– Connect suction hose -A- to container »1« with distilled water.
– Connect drain hose -arrow- to plug-in connector -B- on valve
block.
250
Rep. gr.19 - Cooling
⇒ page 57 .
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.