Removing And Installing Auxiliary Radiator - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
4.7 Removing and installing auxiliary radia‐
tor
⇒ "4.7.1 Removing and installing right auxiliary radiator",
page 303
⇒ "4.7.2 Removing and installing left auxiliary radiator",
page 305
4.7.1 Removing and installing right auxiliary
radiator
Note
On vehicles with manual gearbox, the auxiliary radiator is in‐
♦
stalled on the front right side.
Vehicles with dual clutch gearbox are equipped with 2 auxiliary
♦
radiators – on the front right and front left sides.
Special tools and workshop equipment required
♦ Hose clamps, up to Ø 25 mm - 3094-
♦ Drip tray for workshop hoist - VAS 6208-
Removing
– Remove front right wheel ⇒ Running gear, axles, steering;
Rep. gr. 44 ; Wheels, tyres and alignment .
– Remove the noise insulation ⇒ chassis installation work, ex‐
terior; Rep. gr. 66 ; Noise silencer; installation overview - noise
insulation .
– Remove front part of right wheel housing liner ⇒ General body
repairs, exterior; Rep. gr. 66 ; Wheel housing liners; Removing
and installing front wheel housing liner .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
303
4. Radiator/radiator fans