Removing And Installing Electric Coolant Pump - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
2.6 Removing and installing electric coolant
pump
Special tools and workshop equipment required
♦ Hose clamps, up to Ø 25 mm - 3094-
♦ Hose clip pliers - VAS 6340-
♦ Hose clip pliers - VAS 6362-
Removing
Note
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Re-install all heat insulation sleeves in the same locations when
installing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Coolant pump/thermostat assembly
277