Seat Ateca 2017 Workshop Manual page 210

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
16 - Bolt
❑ 9 Nm
17 - Chain tensioner
18 - O-ring
❑ Always renew after removing
❑ Lubricate lightly with engine oil
19 - Valve for oil pressure control - N428-
❑ Removing and fitting
20 - Bolt
❑ Tightening torque
21 - Oil strainer
22 - Oil pump
❑ Removing and fitting
23 - Bolt for oil pump
❑ Must be renewed if removed
❑ 8 Nm +90°
24 - O-ring
❑ Always renew after removing
❑ Lubricate lightly with engine oil
25 - Bolt for oil suction pipe
❑ Must be renewed if removed
❑ 4 Nm +45°
26 - Bolt for sump
❑ Must be renewed if removed
❑ Tightening sequence
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
27 - for oil sump - lower part
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
❑ Tightening sequence
❑ Sheet-metal or plastic
❑ Removing and fitting
Oil sump upper part 14 bolts - torque and tightening sequence
• Renew bolts after removing.
• Always use 14 bolts.
– Tighten bolts in stages in the sequence shown.
stage Bolts
1. -1 ... 14-
2. -1, 2-
3. -3 ... 9-
4th -10-
5th -11 ... 14-
202
Rep. gr.17 - Lubrication
⇒ page 231
⇒ Item 1 (page 222)
⇒ page 213
⇒ page 203
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 204
⇒ page 203
Specified torques/turning further an‐
gle
8 Nm
Turn 180° further
Turn 45° further
Turn 180° further
Turn 90° further