Seat Ateca 2017 Workshop Manual page 449

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Fit screw-type clip on turbocharger.
CAUTION
Danger of accident from weight of catalytic converter.
– Seek help from a second a mechanic for the following work.
– Fit catalytic converter to turbocharger. Attach screw-type clip
of catalytic converter loosely without tightening it.
– Tighten nuts and screw-type clip
position of screw-type clip
– Installing heat shield of steering rack ⇒ Running gear, axles,
steering; Rep. gr. 48 ; Steering rack; Assembly overview -
steering rack .
– Tighten bolt -1- for the lines of the pressure differential sender
for particulate filter - G1037- -2-.
– Install lambda probe 1 behind catalytic converter - GX7- -3-.
– Install propshaft ⇒ Rep. gr. 39 ; Propshaft; Removing and
installing propshaft .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
⇒ page 415
⇒ page 415 .
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
. Note installation
441
2. Emission control