Removing And Installing Front Body Acceleration Senders G341 / G342 - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Release lugs -arrows-.
– Pull the support from its installation position.
– Release release lever -1- in -direction of arrow-.
– Unplug the electrical connector -2-.
– Press lugs -3- and -4- to rear.
– Slide electronically controlled damping control unit - J250-
-5- downward out of retainer -6-.
Installing
Installation is carried out in reverse order, noting the following:
– Push control unit -1- into bracket -2- until lug -arrow- engages
in retainer.
– Function "Replace control unit" must be performed with ⇒ Ve‐
hicle diagnostic tester if electronically controlled damping con‐
trol unit - J250- has been renewed.
– If the reference position has been re-adapted, the front camera
for driver assist systems must be recalibrated on vehicles with
lane departure warning function
⇒ "4.1 Calibrating front camera for driver assist systems", page
335 .
1.3 Removing and installing front body ac‐
celeration senders -G341- / -G342-
Special tools and workshop equipment required
278
Rep. gr.43 - Self-levelling suspension