Seat Ateca 2017 Workshop Manual page 440

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Remove catalytic converter -1- through the tunnel opening by
twisting 180º around its axis.
Installation
– Insert screwdriver -2- into recess -arrow- on turbocharger, and
lever out seal -1-.
– Insert new seal.
– Fit screw-type clip on turbocharger.
CAUTION
Danger of accident from weight of catalytic converter.
– Seek help from a second a mechanic for the following work.
– Fit catalytic converter to turbocharger. Attach screw-type clip
of catalytic converter loosely without tightening it.
– Tighten nuts and screw-type clip
position of screw-type clip
– Installing heat shield of steering rack ⇒ Running gear, axles,
steering; Rep. gr. 48 ; Steering rack; Assembly overview -
steering rack .
432
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 415 . Note installation
⇒ page 415 .