Installing Engine - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unclip right mounting -1- for engine cover panel.
– Engage lifting tackle - 2024 A- on engine and workshop hoist
- VAS 6100- .
– In order to match the lifting tackle to the centre of gravity of the
engine, the holes in the hook rail must be allocated as shown
in the illustration.
– The support hooks and dowel pins on the lifting tackle must
be secured with locking pins -arrows-.
– Lift engine off engine and gearbox jack - VAS 6100- using
workshop hoist - V.A.G 1383 A- .
– Screw the gearbox end of the engine to the engine and gear‐
box support - VAS 6095- as shown in the illustration.
1.5

Installing engine

Specified torques
Note
Tightening torques apply only for lightly greased, oiled, phos‐
♦
phatised or blackened nuts and screws.
Additional lubricants such as engine or gear oil may be used,
♦
but do not use lubricants containing graphite.
All parts used must be greased.
♦
Tolerance for tightening torques: ± 15 %.
♦
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
39