Seat Ateca 2017 Workshop Manual page 80

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Fitting
– Clean contact surface and sealing surface.
– Slide seal -arrow- onto thrust piece - T10354- .
• Closed side of oil seal faces towards thrust piece - T10354- .
– Slide seal -arrow- with thrust piece - T10354- onto clamping
pin - T10531/2- , and fit it to lower timing chain cover.
– In addition, fit thrust pad - T10375- , and screw on flange nut
- 10531/4- .
– Using 21 mm open-end spanner, tighten flange nut until seal
has been pressed in as far as stop.
Note
Renew bolt for vibration damper.
♦
Renew O-ring.
♦
Continue installation following reverse order for removing. The
following must be taken into account:
– Fit the vibration damper
Specified torques
♦ ⇒ "1.1 Exploded view - cylinder block (pulley end)", page 58
72
Rep. gr.13 - Crankshaft group
⇒ page 61 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.