Seat Ateca 2017 Workshop Manual page 85

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Cut off nozzle on tube at front marking (∅ of nozzle approx. 2
mm).
– Apply silicone sealant as shown to clean sealing surface of
sealing flange.
♦ Thickness of sealant bead: 2 to 3 mm.
Note
The sealing flange must be installed within 5 minutes after ap‐
♦
plying the silicone sealant.
The line of sealant must not be thicker than prescribed, as
♦
otherwise excessive sealant will enter the sump and obstruct
the strainer in the oil intake pipe.
Check sealing flange; it must be free of kinks and damage.
♦
The sealing lip must face engine following installation. If the
♦
sealing lip is pressed outwards during installation, there may
be loss of oil due to leakages.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
2. Cylinder block, gearbox end
77