Seat Ateca 2017 Workshop Manual page 305

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Use the removal wedge -1- to press both sides of locking tab
- 3409- away from the engine compartment
-in the direction of the arrow-.
– Pull radiator out of mountings at bottom.
– Remove radiator from water radiator for charge air cooling cir‐
cuit.
– Remove radiator (top section).
Fitting
Install in the reverse order of removal, observing the following:
Note
If there are minor dents in the fins, refer to repair instructions
♦
⇒ page 10 .
Replace the O-rings.
♦
The coolant in the entire system must be changed if the radi‐
♦
ator is renewed.
– Install radiator cowl
– Replenish coolant ⇒ page 244
Specified torques
♦ ⇒ "4.1 Exploded view - radiator/radiator fans", page 291
♦ ⇒ "4.3 Exploded view - radiator cowl and radiator fans",
page 295
4.4.2 Removing and installing radiator, variant
2
Special tools and workshop equipment required
♦ Drip tray for workshop hoist - VAS 6208-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 300 .
.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
297
4. Radiator/radiator fans