Seat Ateca 2017 Workshop Manual page 360

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Rotate assembly sleeve - T10133/6- (knurled section no lon‐
ger points to seal).
– Now push oil seal to end of assembly cone .
– Only for version -B- injectors: fit M8 washer -A- onto injector.
– Place the assembly cone - T10133/5- with seal onto the injec‐
tor from front.
– Slide seal with assembly sleeve - T10133/6- onto injector.
– Remove assembly cone - T10133/5- , and push combustion
chamber ring seal into groove for combustion chamber ring
seal using assembly sleeve - T10133/6- -arrow-.
352
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.