Seat Ateca 2017 Workshop Manual page 434

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Assemble engine support - T50015A- as shown in the dia‐
gram.
♦ Screw a bolt M8 x 30 mm -1- with a washer into the threaded
hole of the subframe.
♦ Fit engine support - T50015A- to the supports of the positioner
- T10533/2- using the bolt M8 x 30 mm -2- with a washer and
nut.
♦ Affix support of the positioner - T10533/2- in the threaded hole
of the gearbox using the bolt M12 x 20 mm of the positioner -
T10533/4-
– By turning the spindle, the engine/gearbox unit is moved for‐
wards until there is a small tension. Avoid collisions of com‐
ponents.
Vehicles with all-wheel drive
– When detaching and fixing the propshaft, it is always neces‐
sary to ensure that the socket -arrow- is not damaged.
– Detach propshaft of the bevel box and place it to the side on
the left.
– Cover propshaft in the front area with a cloth to prevent dam‐
age to the surface coating.
– Secure exhaust pipe -1- on propshaft with tensioning strap
-2-.
Continued for all vehicles
– Pull out catalytic converter through the tunnel opening by
twisting 180º around its axis.
426
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.