Seat Ateca 2017 Workshop Manual page 35

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Secure the support bridge - T10323- with a bolt on inside rear
threaded hole for subframe.
– To do this, the securing bolt for subframe can be used.
– Put a cloth -A- on support .
– Pull propshaft off bevel box, and lay it to one side.
Vehicles with front differential lock
– Unplug electrical connector -arrow- of control unit for longitu‐
dinal locks - J647- .
Continued for all vehicles
– Remove bolt -arrow- and push bracket for electrical wiring
harness to one side.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Secure adapter -T10359/3- to engine support - T10359- , as
shown in illustration.
– Use locking element -A- from gearbox support - T10359/2- to
secure pin -3282- to engine support.
– Insert the engine bracket - T10359- into the engine and gear‐
box jack - V.A.G 1383 A- .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
27