Seat Ateca 2017 Workshop Manual page 43

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Remove nuts -arrows- and detach bracket at front of oil pan.
Note
The studs are welded on to the front of the oil pan.
Vehicles with four wheel drive:
– Unscrew bolts-1, 2- and remove the holders of the bevel box.
Continued for all vehicles:
– Unplug electrical connector -2-.
Note
Use cloth to catch escaping coolant.
– Release hose clips -arrows- and detach coolant hoses from
gear oil cooler.
– Remove bolts -1- and move coolant valve for gearbox - N488-
clear to one side.
– Seal off open pipes/lines and connections immediately with
clean plugs from engine sealing cap set - VAS 6122- .
Note
Ignore -3094- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
35