Seat Ateca 2017 Workshop Manual page 277

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
1 - Connecting piece
2 - O-ring
❑ Renew
❑ Lubricate with coolant
3 - Centralising pin
4 - Bolt
❑ Tightening torque and
sequence ⇒ page 270
5 - Gasket
❑ Renew
6 - Coolant pump
❑ Removing and fitting
⇒ page 276
❑ New coolant pump: re‐
move protective cap
7 - Bolt
❑ Tightening sequence
⇒ page 270
8 - Notched belt
❑ For coolant pump
❑ Removing and fitting
⇒ page 273
9 - Bolt
❑ 9 Nm
10 - Toothed belt guard
11 - Bolt
❑ Left-hand thread
❑ Renew
❑ 10 Nm + turn +90° fur‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
ther
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
12 - Ribbed belt drive pinion
❑ Observe installation position
13 - Oil seal for balance shaft (inlet side)
❑ Replace ⇒ page 92
14 - Balancing shaft
15 - Gasket
❑ Renew
16 - Bolt
❑ 9 Nm
17 - Connection
18 - Spring
19 - Gasket
❑ Renew
20 - Actuator for engine temperature regulation - N493-
❑ Removing and fitting ⇒ page 282
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Coolant pump/thermostat assembly
269