Seat Ateca 2017 Workshop Manual page 145

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
With markings on cylinder head
– Turn vibration damper to "TDC" position using counter-hold
tool - T10355- .
• The markings -1- on the camshaft chain sprockets must be
aligned with markings -2- and -3-.
• The notch on the vibration damper must align with the marking
on the lower timing chain cover -arrow-.
Without markings on cylinder head
– Turn vibration damper to TDC position using counter-hold tool
- T10355- .
• The markings -1- on the camshaft chain sprockets must face
upwards.
• The notch on the vibration damper must align with the marking
on the lower timing chain cover -arrow-.
Continued for all vehicles
– Remove lower timing chain cover
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Note
The timing valves have a left-hand thread.
♦
Depending on the version, different timing valves may be in‐
♦
stalled. Use the appropriate assembly tool -1-.
– Turn assembly tool - T10352/2- or -T10352/4- in
-direction of arrow- to remove left and right timing valves.
Depending on the current model version of the timing valve, one
of the tools shown must be used:
♦ Installation tool - T10352-
♦ Installation tool - T10352/1-
♦ Installation tool - T10352/2-
♦ Installation tool - T10352/3-
♦ Installation tool - T10352/4-
⇒ page 123
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
.
137
3. Chain drive