Cylinder Block, Gearbox End; Exploded View - Cylinder Block, Gearbox End - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
2

Cylinder block, gearbox end

⇒ "2.1 Exploded view - cylinder block, gearbox end", page 73
⇒ "2.2 Removing and installing flywheel", page 74
⇒ "2.3 Removing and installing sealing flange (gearbox end)",
page 75
2.1

Exploded view - cylinder block, gearbox end

1 - Flywheel
❑ Removing and fitting
⇒ page 74
❑ Can only be installed in
one position (out of step
bolts)
2 - Dowel sleeve
3 - Sealing flange on gearbox
side
❑ with shaft seal
❑ Renew
❑ Removing and fitting
⇒ page 75
❑ Before installing, re‐
move oil residue from
crankshaft journal using
a clean cloth.
❑ Guide sleeve is not to be
removed until sealing
flange has been slipped
onto crankshaft journal
4 - Cylinder block
5 - Bolt
❑ Observe tightening se‐
quence ⇒ page 74
6 - Intermediate plate
❑ Version fitted in vehicle
may differ from illustra‐
tion
❑ Must sit on dowel
sleeves
❑ Do not damage or bend
when assembling.
❑ Is suspended on the gasket
7 - Dowel sleeve
8 - Bolt
❑ For dual-mass flywheel
❑ Renew
❑ 60 Nm +90°
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 74
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
2. Cylinder block, gearbox end
73