Removing And Installing Intake Manifold - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
13 - Intake manifold sender - GX9-
❑ Removing and fitting
14 - Bolt
❑ Tighten crosswise in several stages
❑ Qty. 8
❑ 9 Nm
15 - Ball head stud
❑ For engine cover panel
❑ 5 Nm
16 - Support plate
❑ For electrical connector
17 - Bolt
❑ 5 Nm
18 - Nut
❑ Tighten crosswise in several stages
❑ Qty. 2
❑ 9 Nm
19 - Gasket
❑ Renew after removing
20 - Vacuum hose
21 - Intake manifold flap valve - N316-
22 - Vacuum hose
23 - Support plate
❑ For electrical connectors
24 - Bolt
❑ 5 Nm
4.2

Removing and installing intake manifold

Special tools and workshop equipment required
♦ Measuring tool - T10118-
⇒ page 374
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
359
4. Suction hose