Seat Ateca 2017 Workshop Manual page 24

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Remove bolts -arrows- and nuts -1-.
– Remove heat shield -2-.
– Unscrew bolts -arrows- on bracket for pressure differential
sender for particulate filter - G1037- -1-.
– Move bracket for pressure differential sender for particulate
filter - G1037- -1- to the rear.
Continued for all vehicles
CAUTION
The fuel system is pressurised.
Risk of injury due to fuel which may spurt out.
– Wear safety goggles.
– Wear protection gloves.
– Release pressure: place clean cloth around connection and
carefully open connection.
– Disconnect hose couplings -1- and -2- ⇒ Rep. gr. 20 ; Plug-
in connectors; Disconnecting plug-in connectors . Unfasten
hoses from expansion tank -3-.
– Release hose clips -1- and -2- and detach coolant hoses.
16
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.