Adjusting Assembly Mounting - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Screw the spindle of the engine support supplement set -
T40093 /3- -6- to the adapter - T40093/3-6- -A-.
– Connect, fit and tighten the spindle engine support supple‐
ment set - T40093 /3- -6- to the adapter - T40091/3- -2- over
the square section tube - T40091/1- -7-.
– Hook the karabiners on the spindles - 10 - 222 A /10- -5- into
the engine lifting eyes.
– Take up weight of engine/gearbox assembly with spindles, but
without raising it.
2.6

Adjusting assembly mounting

Sequence of operations
– Remove battery tray ⇒ Electrical system; Rep. gr. 27 ; Battery;
Removing and installing battery tray .
– Support engine and gearbox in installation position
⇒ page 51 .
– Unscrew engine mounting bolts -arrows- one after the other
and renew them (if not already renewed when installing en‐
gine).
– First screw bolts in loosely.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Using assembly lever, adjust engine/gearbox assembly so
that specifications listed below are attained:
• There must be a distance of -a- = 10 mm between engine
support -2- and engine mounting -1-.
• Side surface of the engine support casting should be located
parallel to support arm of engine mounting.
• Distance -b- = distance -b-.
Note
Distance -a- = 10 mm can be checked with a metal rod of suitable
size, or similar.
– Tighten bolts of engine mounting.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
55
2. Assembly bracket