Seat Ateca 2017 Workshop Manual page 312

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Remove front bumper cover ⇒ General body repairs, exterior;
Rep. gr. 63 ; Front bumper; Removing and installing front
bumper cover .
– Pull air duct -A- in direction of arrow off auxiliary radiator.
– Set drip tray for workshop hoist - VAS 6208- underneath.
– Clamp off coolant hoses -A- and -B- with hose clamps - 3094- .
Open spring-type clips, and remove hoses from auxiliary ra‐
diator.
– Remove bolts -arrows-. Remove auxiliary radiator -A- upwards
from bracket.
Installing
Install in the reverse order of removal, observing the following:
– Install front bumper cover ⇒ General body repairs, exterior;
Rep. gr. 63 ; Front bumper; Removing and installing front
bumper .
Install in the reverse order of removal, observing the following:
– Install front part of left wheel housing liner ⇒ General body
repairs, exterior; Rep. gr. 66 ; Wheel housing liners; Assembly
overview - Front wheel housing liner .
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Install wheel ⇒ Running gear, axles, steering; Rep. gr. 44 ;
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Wheels, tyres; Wheel change .
Specified torques
♦ ⇒ "4.2 Exploded view - auxiliary radiator", page 292
304
Rep. gr.19 - Cooling
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.