Seat Ateca 2017 Workshop Manual page 151

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Fit oil pump chain onto three-part chain sprocket assembly.
– Swivel three-part chain sprocket assembly towards engine in
direction of -arrow- and secure on crankshaft. The marks must
coincide -arrows-.
I - Screw clamping pin - T10531/2- into crankshaft, and tighten it
by hand.
II - Fit turning over tool - T10531/3- . Screw on flange nut -
T10531/4- by hand. Slightly move turning over tool back and forth
with a 32 mm open-end spanner. While doing so, retighten flange
nut until the chain sprocket is securely seated on the crankshaft
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
splines. Now, tighten tensioning bolt -A-.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Position link of drive chain for balancer shafts with coloured
marking -arrow- at marking of triple chain sprocket. Install ten‐
sioning rail -1- and guide rail -2-. Tighten bolts -3-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
143
3. Chain drive