Removing And Installing Coolant Temperature Sender At Radiator Outlet G83 - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unplug connector -1-.
Note
Place a cloth underneath to catch escaping coolant.
♦
Insert new coolant temperature sender - G62- immediately in‐
♦
to union to avoid loss of coolant.
– Unscrew bolt -2-, coolant, remove temperature sender - G62-
- item 3-.
Fitting
Install in the reverse order of removal, observing the following:
Note
Replace the O-rings.
– Check coolant level
Specified torques
♦ ⇒ "2.3 Exploded view - coolant temperature sensors",
page 273
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
2.11 Removing and installing coolant temper‐
ature sender at radiator outlet - G83-
Removing
• Engine cold.
– To relieve residual pressure in cooling system, open filler cap
-arrow- on coolant expansion tank briefly and then close cap
again (it should click into place).
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
⇒ page 240 .
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Coolant pump/thermostat assembly
285