Seat Ateca 2017 Workshop Manual page 178

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Using assembly tool - T40266- , turn inlet camshaft in direction
of -arrow 1- until camshaft clamp - T40271/2- can be removed
from between teeth of chain sprocket in direction of arrow
-2-. Then, relieve tension from camshaft.
– Remove camshaft clamp - T40271/1- and -T40271/2- .
– Fit and tighten bolts -arrows-. Specified torque
⇒ Item 4 (page 106)
– Lubricate holes -arrows- with engine oil.
Note
If a spring pin -1- is fitted, and if the bearing saddle is to be re-
installed, the spring pin must be driven back. Clamping sleeve
must be flush with bearing saddle at cylinder head end.
– Fit bearing saddle. Do not cant bearing saddle, while doing so.
Screw in bolts -1...6- by hand.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
170
Rep. gr.15 - Cylinder head, valve gear
.